Intermodal module B is now completely wired and is ready for scenery. Last night I finished off the soldering and installed the Tortoise motor (there is only one turnout on this module) . All the PowerPole connectors for power feeds between modules are wired up, along with the PowerPole connectors that carry the block detection wiring between intermodal module A and B (the block detector board, Digitrax BDL168, is on module A).

Tonight I will attempt to complete module A – at least I will get the wiring finished, but hopefully will be able to finish installing the turnout motors as well. I had to move the bus location slightly at the end of module B in order to install the Tortoise motor there, but that might not be possible on module A. I have a remote mounting kit for the Tortoise motor which I might have to use. At present I am not sure whether I will install motors on the yard tracks or find a method to switch them manually.

So, one board done and another almost done…the end modules (kindly donated by Jim Bainbridge – thanks Jim!!) need slight wiring alterations for the installation of block detection, but already have the PowerPole connectors in place for the power feeds.

I have successfully tested two signals on the main modules (intermodal modules A & B), and these work correctly, running off a JMRI PanelPro panel through the Digitrax BDL168 block detector and the Digitrax SE8C signal controller. Now all I need to do is finish installing the signals! I have been considering purchasing a few cantilever signal gantrys for the main tracks, as that will make signal installation a lot simpler, and will require less signals, as my main tracks are both bi-directional.

However, no rush for that as those can be installed at a later stage.

Right, back to work now…must earn some money to pay for all this!!