Videos
03 January 2008
The first video showing signalling on Rochelle Intermodal. I am just using one signal for now just to test the system. I am using the Digitrax SE8C Signal Controller in conjunction the BDL168 Block Detector, with signals controlled by JMRI’s Panel Pro. This video shows a loco entering a block with a green signal, then the signal changing to red when the loco has entered, and changing to green again when the loco has left the block
This second video shows the JMRI Panel Pro screen as the loco enters block 1, showing the signal change to red (block 1 is at the bottom of the screen), then to green again as the loco leaves the block. The signal is the icon to the right on block 1.
23 December 2007
The first complete circuit run of Rochelle Intermodal, excluding one board (which is almost finished). This first video shows the PanelPro screen, showing track 2 going active (track 2nd from bottom of screen, occupancy changes to red)
This video shows two trains running round the layout, shown from the computer end of the layout
This video shows two trains running round the layout, shown from the opposite end of the layout to the previous video
19 September 2007
I built a test board to test the BDL168 block detector board, consisting of track with 3 sections. These video show a closeup of the lights on the BDL168 showing the progress of the loco along the track, as well as a loco moving along the track, with the lights on the BDL168 showing the progress.
This video shows a loco moving along the track, with the lights on the BDL168 showing the progress
