And…Action!

June 5th, 2015

Well, finally the majority of the wiring on my new yard board is completed – apart from 2 point motors still to install.  Here’s the completed wiring on the West side of the yard:

I even managed to test run a loco yesterday – so far, only one frog that needed a polarity change.  I’ll try post a video this weekend of a test run.  So, just the two point motors to install – one of them needs a new hole made, as the current one is too close to the edge of the board, meaning the Seep doesn’t fit properly.  So, I have to retrofit a hole on the other side of the throw bar…always a pain with an already laid point!  The other point needs a rethink as there is no space for a Seep due to the proximity of the other point motors.  So, either I use a remote mount option, or I get a motor like a Cobalt or similar small motor, which can fit in the space.  I’ll have a look into these new servo point motors, as they might be the solution.  Also need to find out if the DCC Concepts ADS-2fx decoder can handle a solenoid and a momentary point motor at the same time, some decoders can.

So, some investigation to do, but in the meantime will be getting the layout wall ready for the yard supports so I can test fit it.  I’ll be scenicking the yard before installing as much easier than trying to do that afterwards.  I’ll also be testing out the one dwarf signal and connecting it to the Digitrax SE8C signal decoder already installed under the intermodal yard.