Progress update
Peter Borcherds April 29th, 2015
I’ve finally got round to starting the point motor installation on the new yard board. I’ve wired up 10 Seep PM-1 point motors – for the first time I have seen sense and have done all the wiring on the workbench! Much simpler and fewer solder burns!
I have just finished installing the first two motors, including attaching the first of two to a 2-way DCC Concepts ADS-2fx Point Motor decoder.
The other 8 point motors will be attached to a CML DAC20 point decoder. I’ll be setting up routes using these two decoders to make it easy to set points into and out of the yard, and these will all be controlled via a local control panel run by a CML DTM30 Towermaster Controller.
Once the points have been installed I’ll be running the main power bus and then installing the Digitrax BDL168 block detector and PSX-1 circuit breaker.
More updates to come soon!